DIY Bond & Seal

• Brush a light coat of Bond (Step 1) to the base of your lash and apply adhesive where the base of the cluster will connect with your natural lashes
• Do not  brush the adhesive all the way up your lash (do not apply mascara before the bond)
•  Once the bond is applied, wait for the bond to go tacky
• Work in sections as this will give you time to apply the bond and clusters with ease
• Pick up your cluster from the end section of the lash with your Feebeea Makeup applicator (not the base.)
• Place the cluster underneath your natural lashes by lifting the lash cluster against the root of your natural lashes. (you may need to lift your eyelid upwards with your opposite hand)
• Once all of your clusters are in place Apply the  Seal (Step 2) using a dabbing motion to the base  of your finished lashes. (Do not brush through your clusters) 
• The seal will eliminate any sticky residue and cure the adhesive bond.
• Once your lashes are set in place, use your Feebeea Makeup Lash Applicator to squeeze the clusters in place to secure them into place. (Make sure you clean your lash applicator so there isn't any bond residue on it prior to the final squeeze). This will stop your lashes from lifting.
• Your lashes are ready to go! ( Avoid getting them wet)

Our Remover is the perfect solution for safely and easily removing our DIY bond & seal adhesive. Infused with white mineral oil, it effectively dissolves the adhesive without damaging your natural lashes. Not only does it remove lash clusters with ease, but it also leaves your lashes nourished and healthy. Say goodbye to harsh removal methods and hello to our gentle Remover for a hassle-free experience.

Delivery priced at checkout, Standard delivery  1-3 days